Doulton replacement vino tap / spigot is a genuine OE part designed for stainless steel gravity water filter systems. Please note that this part is required for the functionality of your filter gravity filter system.
Tap Assembly Installation Instructions.
Remove the plastic nut.
Moisten both rubber washers with clean water
Place one washer over the threaded part of the tap and then insert the threaded part through the hole in the side of the bottom chamber.
Replace the second rubber washer onto the thread protruding through to the inside of the bottom chamber and secure the tap in place with the nut.
To achieve a tighter seal, hold the outlet tap until the nut is hand tight.
Then hold the nut and tighten the assembly by rotating the tap body through at least a quarter turn to reach the upright position